Cross section

Use the cross-section tool in 3D view to cut vertically or horizontally across a region on the inspection site, and to assess the cut region in a 2-dimensional form. You can adjust the plane slider to widen the section or move its position around the cross-sectioned area.

Activate Cross section tool from the toolbar upleft by clicking and select 2 points to form a line. Vertical cross section is created just by clicking, horizontal cross-section by holding Shift while clicking. Adjust the position or width of the cross-section with the slider. Reset the positioning with the reset icon and deactivate the tool by clicking on it again from the upleft toolbar.

Wall analysis

The wall analysis tool can be used to analyse indentations or protrusions on a wall. Select a reference plane and use the slider to highlight abnormal regions.

Activate the Wall analysis tool from the toolbar upleft by clicking. Pick 3 points on the point cloud for a reference plane, and adjust the distance from the reference plane by moving the slider (distance shown in meters). The Blue region is deeper in proximity, red surfaces are closer. Deactivate the tool by clicking on it again from the upleft toolbar or by pressing ESC.

Look for areas where color seems out of place to identify indentations or protrusions.

Updated on: 24/01/2025